Configuring an RF Gun to work on a new Wifi Network

Configuring an RF Gun to work on a new Wifi Network

Configuring an RF Gun to work on a new Wifi Network

Here are the steps to configure a new Wifi connection on a Motorola RF Gun. The steps may vary by model, but should conform to these general guidelines.

1. Click the Start Menu on the Main Screen:

Pic 1
2. Scroll through the Start Menu options until you get to “Wireless Companion” (Its quite a bit down, near the end)

Pic 2
3. In Wireless Companion Click “Wireless Configurations”

Pic 3
4. From Here to add a new network click “Find WLANs”. You can also go into “Manage Profiles” if you need to delete or change an existing profile.

Pic 4

5. In the “Find Profile” screen you should see a list of all available networks. Use the stylus to click and hold down on the network you need to set up and you should see the context menu to “Create Profile”. Click that option.

Pic 5

6. Here we start the set up. Just Click Next at this screen.

Pic 6

7. Just Click Next Here.

Pic 7
8. If the network has a network key to enter you will likely need to make sure WPA2-Personal is selected here. That is the default setting. Check with your network administrator to confirm this is the correct authentication setting.

Pic 8
9. Just click next here.

Pic 9

10. You will likely need to change this from Hexadecimal to pass-phrase. Then Click Next.

Pic 10
11. If the network will obtain its IP settings automatically, leave these setting alone. Otherwise you can uncheck them and enter a static IP address and other settings.

Pic 11
12. Just click next here.

Pic 12
13. Just Click Next here.

Pic 13

That’s all there is. The device should connect now. If you need to change which wireless network the device is connecting to you can go back to the “Find WLANs” option seen in step 4 and 5 to connect to a specific profile already set up.

Share on Google+Tweet about this on TwitterShare on LinkedInShare on FacebookEmail this to someone